Connection And Calibration; Installation; Connections To Other Equipment - Lexicon CP-1 Owner's Manual

CP-1 Digital Audio Environment Processor
The CP-1 may be installed on a shelf or in a standard 19" equipment rack,
using the optional rack-mounting hardware (Lexicon part #021-06639).
Connect the power cord to a wall outlet or to a switched outlet on the back
of your preamplifier. Observe the following precautions:
• Make sure the remote control receiver, located on the right side of the
front panel, is unobstructed. The remote control must be in line of sight
to this receiver for proper operation. The CP-1 may be placed in a glass-
doored cabinet but smoked glass will make the display hard to read.
• Select a dry, well-ventilated location out of direct sunlight.
• Do not stack the CP-1 directly above heat-producing equipment such as
power amplifiers.
• Avoid placing the CP-1 near unshielded TV or FM antennas. The CP-1
may interfere with some FM tuners if it is placed immediately above or
below them.
• Install two AAA batteries in the CP-1's remote control.
AUDIO
MAIN
PREAMP
OUT
TAPE
OUT/IN
PROGRAM EQ
I
or INPUTS
II
DYNAMIC RANGE
PROCESSOR
VCR, TV, VIDEO
AUDIO
CONTROL CENTER
OUT
MAIN OUT
CD
I
INPUTS
II
VIDEO
DISC
AUDIO OUT
CENTER
REAR
MAIN
CP-1
SIDE
SUB
WOOFER
TAPE
OUT/IN
VCR
or
CASSETTE DECK
CENTER
REAR
MAIN
CP-1
SIDE
SUB
WOOFER
TAPE
OUT/IN
AUDIO or VIDEO
CASSETTE
RECORDER
Connection
Calibration
CENTER
AMP
REAR
AMPS
MAIN
(SPEAKER
POWER AMPS
EQ)
SIDE
AMPS
SUBWOOFER
AMP
CENTER
AMP
REAR
AMPS
MAIN
(SPEAKER
POWER AMPS
EQ)
SIDE
AMPS
SUBWOOFER
AMP
2
and

Installation

Precautions
Connections to
Other Equipment
Connections with an
Audio Preamp
Using the CP-1 as an
Audio Preamp
Page 7