Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7772-K169
Summary of Contents for NCR 7772-K169
- Page 1 Kit Instructions External Speaker 7772-K169 Issue B...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: External Speaker
External Speaker This kit provides an External Speaker for NCR CX7 All-in-One POS (7772). Kit Contents... -
Page 4: Installation Procedure
External Speaker Installation Procedure Warning: Disconnect the AC power cord from the AC outlet and wait 30 seconds before servicing the terminal. 1. Lay the Display face down on a flat surface. Note: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. - Page 5 External Speaker 3. Disconnect the Cables. a. Loosen the thumbscrew of the 180-degree USB-C Cable then disconnect the Cable. b. Remove the Ethernet Cable from the Cable Management Hook then disconnect the Cable. 4. Loosen the two (2) captive screws that secure the Back Cover to the Display.
- Page 6 External Speaker 5. Rotate the Back Cover away from the Display and unhook the Back Cover Tabs.
- Page 7 External Speaker 6. Insert a flat screw driver in the slot of Port C to unsnap the Plate from the display housing. 7. Disconnect the Internal Speaker Cable from the Motherboard and remove the Internal Speaker (2 screws).
- Page 8 External Speaker 8. Route the External Speaker Cable through the port opening as shown and connect the External Speaker Cable to the Extension Cable. 9. Connect the Extension Cable to the Motherboard.
- Page 9 External Speaker 10. Hook the External Speaker into the display housing and snap into place. 11. Secure the External Speaker with a screw. 12. Reinstall the Display Back Cover. 13. Reconnect the 180-degree USB-C Cable and Ethernet Cable. 14. Reinstall the Cable Cover.