GMC HUMMER EV 2022 Manual page 16

the other remote key. Turn the vehicle
off and remove the other remote key
from the vehicle.
3. Turn the vehicle on with the initial
remote key. The DIC welcome message
should display the driver number of the
initial remote key.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on. A DIC welcome
message may indicate the driver number
of the current remote key. See
"Identifying Driver Number" previously in
this section.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately upon releasing SET, press
and hold memory button 1 or 2 matching
the current Driver's remote key number
until two beeps sound. If too much time
passes between releasing SET and
pressing 1 or 2, the two beeps will not
sound indicating memory position were
not saved. Repeat Steps 3 and 4 to try
again.
5. Repeat Steps 1–4 for the other remote
key 1 or 2 using the other 1 or 2 memory
button.
It is recommended to save the preferred
driving positions to both 1 and 2 if you are
the only driver.
To save the common exit seating position to
B
that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat
Exit Memory Recall features, repeat Steps 1–
B
4 using , the exit button.
Manually Recalling Seating Positions
B
Press and hold 1, 2, or button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or
B
buttons may be initiated and will
complete to the saved memory position if
the vehicle is in or out of P (Park).
Seats and Restraints
Enable Automatic Recalls under Vehicle
Personalization Settings
For Seat Entry Memory that begins
.
movement to the preferred driving
position of the 1 or 2 button when the
vehicle is turned on; select the Settings
menu, then Vehicle, then Seating Position,
then Seat Entry Memory, and then Select
ON or OFF. See "Auto Seat Entry Memory
Recall" later in this section.
For Seat Exit Memory that begins
.
movement to the preferred exit position
B
of the button when the vehicle is
turned off and the driver door is open or
opened; select the Settings menu, then
Vehicle, then Seating Position, then Seat
Exit Memory, and then Select ON or OFF.
See "Auto Seat Exit Memory Recall" later
in this section.
See the owner's manual for additional
.
setting information.
Auto Seat Entry Memory Recall
Seat Entry Memory will automatically begin
movement to the seating positions of the 1
or 2 button corresponding to the driver's
remote key number 1 or 2 detected by the
vehicle when:
The vehicle is turned ON.
.
15