Table of Contents
Advertisement
Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Note: The direct access controls are blue.
Table 2-1. Direct access controls
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the On-Screen
Display (OSD), as shown below.
To use the controls:
1.
2.
3.
4.
5.
6.
Icon
Control
Input Change
Image Setup
Brightness
(picture 1)
Press
to open the main OSD menu(picture 1).
Use
or
to move among the icons. Select an icon and press
that function. If there is a sub-menu, you can move between options using
or
, then press
Press
to save.
Press
to move backwards through the sub-menus and exit from the OSD.
Press and hold
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
and allow adjustments to the OSD.
Enables DDC/CI by default. Use OSD Exit Key, press and hold the
5 seconds to disable/enable DDC/CI function. The words " DDC/CI Disable/DDC/
CI/Enable" shows on the screen.
Press "Exit Key" to enter the input Signal meun(picture 2) when the monitor is under
the condition of
"No sync","No Cable" or "power Saving Mode".press
choose input signal.
press "AUTOSCAN" to go back to Auto Scan mode.
Switches the video input source.
Activates automatic image adjustment.
Direct access to Brightness adjustment.
to select that function. Use
for 10 seconds to unlock the OSD
Chapter 2. Adjusting and using your monitor
Description
(picture 2)
to access
or
to make adjustments.
buttons for
or
to
2-3
Hide quick links:
Advertisement
Table of Contents
