Table of Contents
Advertisement
If the battery is fully discharged it may take a
few moments before the charging indicator
appears on the display.
When the battery is fully charged, the battery
charge indicator stops animating and, if your
Vertu phone is switched on, a confirmation
message is briefly displayed.
If your Vertu phone is not charging, try the
following:
Disconnect the charger from the AC outlet.
>
Check that the electrical rating of the AC
>
outlet is compatible with your charger.
Verify that the AC outlet has power and that
>
it is switched on. For example, in many hotel
rooms, AC outlets are used for lighting and
may be switched on and off from remote
locations in the room.
Wait for at least 10 seconds and then
>
re-connect the charger to the AC outlet.
Use another nearby AC outlet that you know
>
is providing power.
If charging still fails, contact Vertu Concierge
>
for further advice.
The vibrating alert is disabled while the charger
is connected to your Vertu phone.
When you want to stop charging your battery,
for example when charging is complete:
Disconnect the charger from the AC outlet.
>
Disconnect the charger from your Vertu
>
phone by pulling the charger connector – do
not pull the cable or adaptor body.
The charger can be used in conjunction with
the data cable. For more information refer to
"Connecting the data cable" on page 24.
Connect the
>
charger body to a
powered AC outlet.
The battery
>
indicator animates,
and a confirmation
message is
displayed if your
Vertu phone is
switched on.
BATTERY
Caution. Do not dispose of batteries in a fire
and always dispose of a battery according to
local regulations. Do not dispose of as
household waste.
Always switch the phone off and disconnect
the charger before removing the battery.
Do not remove the release tab or the
protective plastic film from the battery as this
will damage the battery.
R
EMOVING THE BATTERY
Switch off your Vertu phone and disconnect
>
the charger and any accessories.
01
02
With the back of your Vertu phone facing
>
you, position the back cover release key (01)
very carefully into the slot of the locking
screw (02). Ensure the key does not slip out
of the slot.
03
Turn the locking screw (02) a quarter of a turn
>
anticlockwise, gently pivot (by no more than 45
degrees) and lift off the back cover (03)
towards you as shown. If you accidentally
remove the back cover while the phone is
switched on, the phone will automatically
switch off.
V E R T U
A C C E S S O R I E S
20
Advertisement
Table of Contents
