Product overview
FRU tests
The following table shows the test for each FRU.
FRU
System board
Power
LCD unit
Modem, MDC
or BMDC
MDC-2 or
BMDC-3
Audio
Speaker
PC Card slots
Keyboard
TrackPoint or
pointing device
Hard disk drive
Diskette drive
(continued)
58
MT 2672, 2673, 2884, 2885
Applicable test
1. Diagnostics --> CPU/Coprocessor
2. Diagnostics --> Systemboard
Diagnostics --> Other Devices --> AC
Adapter, Battery 1 (Battery 2)
1. Diagnostics --> Video Adapter
2. Interactive Tests --> Video
1. Make sure the modem is set up correctly.
2. Replace the modem jack and the modem
card in turn, and run the following test in
Diagnostics --> Communication:
a. Lucent Soft Modem Loopback
b. Lucent Soft Modem Dialtone
1. Make sure the modem is set up correctly.
2. Replace the modem jack and the modem
card in turn, and run the following test in
Diagnostics --> Communication:
a. Conexant Smart Modem Interrupt
b. Conexant Smart Modem Dialtone
1. Interactive Tests --> Internal Speaker
2. Diagnostics --> Other Devices --> Analog
Devices AC97 CODEC Test
Interactive Tests --> Internal Speaker
1. Diagnostics --> Systemboard --> PCMCIA
2. Insert a PC Card Wrap Plug into every PC
Card slot, and run Diagnostics -->
Systemboard --> PCMCIA External Loop
1. Diagnostics --> Systemboard -->
Keyboard
2. Interactive Tests --> Keyboard
If the TrackPoint does not work, check the
configuration in the ThinkPad Configuration
program. If the TrackPoint is disabled, select
Enable to enable it.
After you use the TrackPoint, the pointer may
drift on the screen for a short time. This drift can
occur when a slight, steady pressure is applied
to the TrackPoint pointer. This symptom is not a
hardware problem. If the pointer stops after a
short time, no service action is necessary.
If enabling the TrackPoint does not correct the
problem, continue with the following:
v Interactive Tests --> Mouse
Diagnostics --> Fixed Disks
1. Diagnostics --> Diskette Drives
2. Interactive Tests --> Diskette