Lenovo ThinkPad X300 6477 Supplementary Manual page 19

Message
0182: Bad CRC2.
Enter BIOS Setup
and load Setup
defaults.
0185: Bad startup
sequence settings.
Enter BIOS Setup
and load Setup
defaults.
0190: Critical
low-battery error
0191: System
Security - Invalid
remote change
requested.
0199: System
Security - Security
password retry
count exceeded.
01C8: More than one
modem devices are
found. Remove one
of them. Press <Esc>
to continue.
01C9: More than one
Ethernet devices are
found. Remove one
of them. Press <Esc>
to continue.
0200: Hard disk
error
Solution
Checksum of the CRC2 setting in the EEPROM is not correct.
Press F1 to enter the BIOS Setup Utility. Press F9 and then
Enter to load the default setting. Press F10 and then Enter to
restart the system.
Checksum of the startup sequence setting in the EEPROM is
not correct. Press F1 to enter the BIOS Setup Utility. Press F9
and then Enter to load the default setting. Press F10 and then
Enter to restart the system.
The computer turned off because the battery is low. Connect
the AC adapter to the computer and charge the battery, or
replace the battery with a fully charged one.
The system configuration change has failed. Confirm the
operation and try again. To clear the error, enter the BIOS
Setup Utility.
This message is displayed if you enter a wrong supervisor
password more than three times. Confirm the supervisor
password and try again. To clear the error, enter the BIOS
Setup Utility.
Remove one of the Modem Daughter Cards. Otherwise, press
Esc to ignore the warning message. If this does not solve the
problem, have the computer serviced.
Your ThinkPad computer has a built-in Ethernet feature, and
you cannot add another such feature by installing an Ethernet
device such as a Mini-PCI Ethernet Card or an Ethernet
Daughter Card. If this error message is displayed, remove the
Ethernet device that you installed. Otherwise press Esc to
ignore the warning message. If this does not solve the problem,
have the computer serviced.
The HDD or SSD is not working. Make sure that the HDD or
SSD is attached firmly. Run the BIOS Setup Utility; then make
sure the drive is not disabled in the Startup menu.
Chapter 3. Solving computer problems
11