Lenovo ThinkPad X30 2672 Supplementary Manual page 46

Solving computer problems
The timer-wake-with-battery-operation is disabled by default. If you
enable this function, the computer could wake up and begin running
while it is being carried; this could lead to damage to the hard disk drive.
With this risk in mind, you can enable the timer-wake-with-battery-
operation.
1. Turn your computer off and then on again; then, while the message,
2. Click Access BIOS. The System Restart Required window is displayed.
3. Click Yes. The computer restarts, and the BIOS Setup Utility menu
4. With the cursor key, select Config; then press Enter. The Power
5. Select Timer Wake with Battery Operation by pressing Enter.
6. With the F5 or F6 key, select Enabled; then press Enter.
7. Press F10 and Enter to save this setting and exit this utility.
For information about the BIOS Setup Utility, see "BIOS Setup Utility" in
Access IBM, your on-board help system.
Problem:
The Fn+F12 key combination does not cause the computer to enter
hibernation mode.
Solution:
The computer cannot enter hibernation mode:
v If you are using one of the supported communication PC Cards. To
v If the hibernation utility is not installed in Windows 98 or Windows NT.
v If the hibernation mode is not enabled. To enable it, do as follows:
For Windows 98:
1. Start the ThinkPad Configuration Program.
2. Click Power Management.
3. Click the Hibernation tab.
4. Click the Enable hibernation... button.
5. Click the Create Now button.
For Windows NT:
24
®
ThinkPad X30 Series Service and Troubleshooting Guide
"To interrupt normal startup, press the blue Access IBM button" is
displayed at the lower left of the screen, press the Access IBM button.
Rescue and Recovery screen opens.
appears.
submenu is displayed.
enter hibernation mode, stop the communication program, and then
remove the PC Card or disable the PC Card slot. Click the Safely
Remove Hardware icon in the taskbar (for Windows XP) or the Unplug
or Eject Hardware icon in the taskbar (for Windows 2000).
To install the hibernation utility, refer to "Installing device drivers" in
the Access IBM, your on-board help system.