Fisher-Price DRH68 Instruction Sheet page 4

Pedal Hubs
Pedal Axle
Assembly
5
• While holding the pedal hubs on the pedal axle assembly, insert
the pedal axle through the hole in the center of the front wheel.
• Push the pedal hubs into the center of the front wheel until they
are flush with the surface of the front wheel.
Pedal Hub
6
• Turn the front wheel assembly over.
• Insert the remaining pedal hubs on top of and below the pedal
axle and into the hole in the center of the front wheel.
• Push the pedal hubs into the center of the front wheel until they
are flush with the surface of the front wheel.
Assembly
Front Wheel
• Fit the pedal on the pedal axle. Tap the pedal with a hammer until
Pedal Hub
• Pull the pedal up to be sure it is secure. If you can remove it,
• Place the front wheel assembly between the fork arms. Make
• Place a fork cover over the pedal axle on one fork arm.
• Insert two 1,9 cm screws into the fork cover and tighten.
• Repeat this procedure to attach the other fork cover to the
4
7
it is secure.
you have not secured it properly. Tap it with the hammer again.
Fork Cover
8
Pedal Axle
sure the pedal axle fits into the groove at the bottom of each
fork arm.
other fork arm.
Pedal
Pedal Axle
Scrap Block
of Wood
Fork
Arms
Groove