Husqvarna 533RS Operator's Manual page 43

a) Make sure that you operate the socket wrench in
the identified area when you loosen or tighten the
saw blade nut.
To install the cutting attachment guard and the
grass blade (533RS)
1. Put the cutting attachment guard (A) onto the shaft
and tighten the bolt (B) to attach it.
1756 - 001 - 08.06.2022
2. Turn the output shaft to align 1 of the holes in
the drive disc (C) with the related hole in the gear
housing.
3. Put the locking pin (D) in the hole to lock the shaft.
4. Put the grass blade (E), the support cup (F) and the
support flange (G) on the output shaft.
5. Make sure that the drive disc and support flange
engages correctly in the center hole of the grass
blade.
B
6. Attach the nut (H).
7. Tighten the nut to the support flange with the socket
wrench. Hold the shaft of the socket wrench near the
blade guard. Tighten in the opposite direction to how
A
the cutting attachment rotates. Tighten it to a torque
of 35-50 Nm.
H
G
F
E
C
D
43