Selecting A Startup Device; Selecting A Temporary Startup Device - Lenovo ThinkCentre M58e 7268 User Manual

To set SATA Controller, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → ATA Drives Setup →
3. Select the desired devices and settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and
To set Floppy A, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → Floppy Drive Setup →
3. Select the desired devices and settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and

Selecting a startup device

If your computer does not start up from a device such as the disc, diskette, or hard
disk drive as expected, do one of the following to select the startup device you
want.

Selecting a temporary startup device

Use this procedure to start up from any startup device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
1. Turn off your computer.
2. Repeatedly press and release the F12 key when turning on the computer. When
3. Select the desired startup device from the Startup Device Menu and press
Note: Selecting a startup device from the Please select boot device window does
page 49.
SATA Controller.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit
or Discard Changes.
page 49.
Floppy A.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
the Startup Device Menu opens, release the F12 key.
Enter to begin.
not permanently change the startup sequence.
Chapter 4. Using the Setup Utility
51