Table of Contents
Advertisement
5.
Setting up
First, choose to use the adaptor (included in this set) or batter-
ies for operation. Both these methods allow for operation us-
ing wireless 433MHz transmission or cable connection be-
tween the base station and the sensors and setting up for both
methods is as follows:
Base Station:
Battery compartment
Setting up using batteries:
Socket for
Adaptor
Socket for
Thermo-Hygro
Important:
Sensor
PC COM
1)
Port
2)
3)
4)
Sensor sockets
Battery
Compartment
To avoid operating problems, please take note of bat-
tery polarity if inserting any batteries
Pull away the rain cover of the thermo-hygro sensor to reveal the
three sockets (for the wind sensor, rain sensor and the base sta-
tion)
Connect the attached cables of wind and rain sensors to the
corresponding sockets of the thermo-hygro sensor by clicking
them into place
Open the battery cover of the thermo-hygro sensor located below
the three sockets and insert 2 x AA, IEC LR6, 1.5V batteries and
close the cover
Open the base station's battery cover located at the back of the
unit and insert 3 x AA, IEC LR6, 1.5V batteries into the battery
compartment and close the battery cover
Thermo-Hygro Sensor
Battery Cover
Sensor sockets
Advertisement
Table of Contents
