Table of Contents
Advertisement
•
Disconnect spark plug wire and move away from
spark plug to prevent accidental starting.
Using Your Lawn Mower
WARNING:
Do not operate the mower
without mulching baffle, discharge chute or
grass catcher properly installed.
•
For best results, do not cut wet grass. It may stick to
the underside of the mower, preventing proper
discharge of grass clippings, and could cause you
to slip and fall. New grass or thick grass may
require a narrower cut.
•
For a healthy lawn, always cut off one-third or less
of the total length of the grass.
Move the shift lever only when the engine
IMPORTANT:
is running. Changing the shift lever setting with the
engine off can cause damage to the mower.
Mulching
Be sure that the lawn is clear of stones,
IMPORTANT:
sticks, wire, or other objects which could damage lawn
mower or engine. Such objects could be accidently
thrown by the mower in any direction and cause serious
personal injury to the operator and others.
For effective mulching, do not cut wet grass. New or
thick grass may require a narrower cut. If the grass has
grown in excess of 4", mulching is not recommended.
SECTION 6: MAKING ADJUSTMENTS
WARNING:
Do not at any time make any
adjustments without first stopping engine and
disconnecting spark plug wire.
Handle Height
Your mower is shipped with the handle in the higher
height position. To lower the height, proceed as follows:
•
Remove the starter rope from the rope guide.
•
Remove the wing nuts and carriage bolts securing
the upper handle. Remove and lay the upper
handle out of the way, being careful not to bend or
kink the cables.
•
Remove the hairpin clips from the weld pins on the
handle brackets and remove the wing nuts and
carriage bolts from the upper hole on the handle
mounting bracket.
•
Press out on the legs of the lower handle and
remove lower handle from the mower.
WARNING:
object, stop the engine. Remove spark plug
wire from the spark plug and thoroughly inspect
for any damage. Repair the damage promptly
before restarting and operating the mower.
Mow using the side discharge to reduce the grass
height to 3.25" maximum before mulching.
Bagging Grass Clippings
You can use the grass catcher bag to collect clippings
while you are operating the mower.
•
Attach grass catcher following instructions on page
8 of this manual. Grass clippings will automatically
collect in the bag as you run the mower.
•
Operate the mower till the grass bag is full.
•
Stop engine completely by releasing the blade
control handle. Make sure that the unit has come to
a complete stop.
•
While holding the grass bag by both the rear handle
and the lower handle, lift the grass bag straight up
off the adapter. The chute door will move the rope
out of the way of the bag.
•
Continue to hold the lower handle and raise the
rear of the grass bag up toward your chest. The
grass bag will open and the grass clippings will
disperse. When replacing the grass bag, be sure
the top of the bag rests on the wire support
between the handles.
•
Turn lower handle around so the notch on the
bottom of the lower handle is facing forward.
See Figure 12.
Lower Handle
•
Reassemble the handles, placing the bottom holes
in the handle over the weld pins in the handle
mounting bracket.
•
Place the hairpin clips in the inner holes in the weld
pins and insert the carriage bolts through the upper
hole on the handle mounting bracket and secure
with plastic wing nuts.
•
Reassemble the upper handle to the lower handle.
•
Attach the starter rope as instructed on page 8.
11
If the mower strikes a foreign
Notch
Figure 12
Advertisement
Table of Contents
