Peak/Average; Channels - Lab.gruppen PLM Series PLM 10000Q User Manual Addendum

▸
amp output current
output current relative to its maximum safe value.
(This is the value at which the CPL becomes
active.)
▸ amp output voltage
output channel's voltage relative to the voltage
permissible, regardless of ISVPL setting.
▸ amp output power
channel's power relative to the maximum rated
power.
▸ Total output power
power (sum of all channels in that Frame) relative
to the maximum rated power.

5.5.2 peak/average

The peak and average buttons in the select
dimension box determine whether the data
displayed on the graph is the log of peak values for the
parameter being displayed, or an average value.
If peak is selected, the curves displayed will be of
the highest values attained by each parameter within
the two minute sample period.
If average is selected, the curves will be of points
representing the average of the values measured
during the sample period.

5.5.3 Channels

The graph can display data for any power output
channel which is assigned to the currently selected
Module, or any combination of channels. The number
of channel buttons which appear in the select
channel(s) box will depend on how the Module is
configured. The Channel buttons are labeled with the
names allocated to them by the configuration which
has been loaded into the Module. The curves on the
graph are color coded, with a key color shown below
each channel button.
The select/Deselect all button toggles states to
either select or deselect all channels on the selected
module.
When only one channel is selected, clicking
on the graph will display the time and sample
number for that particular sample on the
status line.
– Shows the PLM channel's
– Shows the power
– Shows the power output
- Shows the total output
A white dot is displayed on the graphs if a
powercycle of the frame was performed
during the sampling period.
Dolby Lake Controller User Manual PLM Edition Addendum
operation 5
19