Toshiba Satellite Click 10 Series User Manual page 91

Federal Communication Commission interference statement (FCC)
Federal Communication Commission Interference Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna. -Increase the separation
between the equipment and receiver. -Connect the equipment into an outlet on
a circuit different from that to which the receiver is connected. -Consult the dealer
or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation
RF Exposure Warning
The equipment complies with RF exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
This equipment should be installed and operated with a minimum distance of 20 centimeters between
the radiator and your body.
User can access the E-Label screen by the following instruction:
Hold Windows Logo on the touch screen for 3 seconds and release.Select "System" option on the displayed Menu.
Taiwan
Article 12
Article 14
Australia and New Zealand regulatory compliance
This equipment incorporates a radio transmitting device, in normal use a
separation distance of 20cm will ensure radio frequency exposure levels
complies with the Australian and New Zealand Standards.
User's Manual
Without permission granted by the NCC, any
company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or
alter original characteristic as well as performance
to an approved low power radio frequency devices.
The low power radio-frequency devices shall not
influence aircraft security and interfere legal
communications;
If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio
communications is operated in compliance with the
Telecommunications Act.
The low power radio-frequency devices must be
susceptible with the interference from legal
communications or ISM radio wave radiated
devices.
7-8