Sony CDP-CX225 Service Manual page 18

SENSOR ALIGNMENT
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
Cam
(1)Rotate the cam and adjust to the position
shown in the figure.
(2) Check that the lever (stopper) assem-
bly secures the disc table as shown in
the figure.
Lever (stopper) assembly
Tepering screwdriver
Luminus board
Bracket (sensor)
(3)Loosen the fixed screw by 60° to 90°, and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed at where the paly botton's LED (green) is switched to
the pause button's LED (orange) (or its reverse).
Bracket (sensor)
Disc table
Fixed screw
Cam
Table assembly
(4) Moving the disc table right and left with a hand after the screw is
fixed, the table will move by the play of a disc table. If the LEDs
light up alternately, the adjustment will be performed correctly)
PLAY button
— 14 —
LEVER (stopper)
assembly
Swing
PAUSE button