GE Voluson E Series Service Manual page 26

Introduction
LABEL/SYMBOL PURPOSE/MEANING
Waste Electrical and Electronic Equipment (WEEE) Disposal. This
symbol indicates that waste electrical and electronic equipment
must not be disposed as unsorted municipal waste and must be
collected separately. Please contact an authorized representative
of the manufacturer for information concerning the
decommissioning of your equipment.
This product consists of devices that may contain mercury, which
must be recycled or disposed of in accordance with local, state, or
country laws. (Within this system, the backlight lamps in the
monitor and the Touch Panel display, contain mercury.)
GOST-R label (Russia Regulatory Country Clearance)
"CAUTION - Consult accompanying documents" This symbol is
used to advise the reader to consult accompanying documents for
important safety-related information such as warnings and pre-
cautions that cannot be presented on the device itself.
"CAUTION - Dangerous electric voltage" (lightning flash with
arrowhead) is used to indicate electric shock hazards. Unplug the
main plug before opening the system!
"Mains OFF" Indicates the power off position of the mains power
switch.
"On/Off" or "Standby"
CAUTION: System shutdown using this button DOES NOT
disconnect the Voluson E-Series from mains voltage!
"Mains ON" Indicates the power on position of the mains power
switch.
"Protective Earth" Indicates the protective earth (grounding)
terminal.
"Equipotential" Indicates the terminal to be used for connecting
equipotential conductors when interconnecting (grounding) with
other equipment.
This symbol indicates that the device is equipped with hardware
for using Continuous Wave Doppler.
This symbols indicate that the product contains hazardous
materials in excess of the limits established by the Chinese
standard GB/T 26572 Requirements of concentration limits for
certain restricted substances in electrical and electronic products.
Every system has a unique marking for identification, the Unique
Device Identification (UDI) Label. The UDI label consists of a
series of (alpha-) numeric characters and barcode which uniquely
identify the Voluson E-Series system as a medical device
manufactured by General Electric.
The Common Mark of Products Circulation certifies that the
products bearing this mark, passed all conformity assessment
(approval) procedures.
1-18
LOCATION
Identification and Rating Plate
(rear side of the system / on plug of each probe)
Identification and Rating Plate
(rear side of the system)
not visible:
- below the cover on read side of Monitor
- on rear side of the Touch Panel
Identification and Rating Plate
(rear side of the system)
various
various
rear of system at mains switch
(on power supply RSP)
ON/OFF Standby button on control console
rear of system at mains switch
(on power supply RSP)
rear of system at mains switch
(on power supply RSP)
rear of system at mains switch
(on power supply RSP)
rear side of the system
rear side of the system
on the plug of each probe
Identification and Rating Plate
(rear side of the system / on plug of each probe)
Upgraded systems
adjacent to the Rating Plate
Identification and Rating Plate
(rear side of the system)
Voluson E-Series Service Manual
5539550APB Revision 6