Table of Contents
Advertisement
Troubleshooting
Symptoms
Source Selection / Source Image Problems
Camport (front
Audio/Video)
source not selectable.
No Camport image.
(front Video)
S-Video Source not
selectable.
No S-Video image.
No S-Video audio.
Antenna/Cable
not selectable.
No Antenna
Cable image.
Rear Audio Video
not selectable.
No rear Audio
Video image.
Possible Cause(s)
• Equipment not connected.
• Equipment not turned on.
• Camport (front Video)
connected.
• Not connected.
• Equipment not turned on.
• S-Video audio not
connected.
• Front Video connected.
• S-Video equipment
connected.
• Not Connected
• Front Video connected.
• S-Video equipment
connected.
* Equipment not turned on.
* Equipment not connected.
Possible Solution(s)
Connect Audio/Video equipment to
front Audio/Video.
Turn on equipment connected to front
Video input.
Disconnect equipment connected to
front Video jack.
Connect S-Video equipment to S-Video In.
Turn on equipment connected to S-Video In.
Connect audio for S-Video to Audio In R - L.
(Use Audio In L jack to connect one audio wire.)
Disconnect equipment connected to front Video.
Disconnect S-Video equipment from
rear jackpack.
Connect over-the-air antenna or cable service
wire to Antenna/Cable jack.
Disconnect equipment from front Video jack.
Disconnect S-Video equipment from
rear jackpack.
Go to Setup menu, select Add/Del/Blank option.
Press 9-9-9 to select AUX. Press MENU
select "Added" in Add/Del/Blnk option in
Setup menu. (See Installer menus.)
Turn on equipment connected to
rear Audio/Video.
Connect equipment to rear Audio/Video.
Page(s)
18/19
18/19
18/19
18/19
14/18/19
18/19
14/19
10/11
18/19
14/19
12/14
Page 53
Advertisement
Table of Contents
