Table of Contents
Advertisement
Installer Menu
13-I. SCAN MODE
Allows variation in the On/Off setup with
CHANNEL Up/Down. You may opt for TV
channels only or TV channels + Off/ON with
the following settings for Scan Mode:
Scan mode
Characteristics
0
Channel Up/Down keys
Change channels only.
1
Channel down below the
lowest channel (or channel
up higher than the highest)
and TV turns off.
14-I. NOT USED
15-I. SLEEP TIMER
When set to 1, the Sleep Timer feature is
available to the user (but no message is
displayed prior to turn-off). When set to 0,
the Sleep Timer is not functional.
16-I. EN. TIMER
Set to 1, Timer functions are available to
user. Set to 0 to disable Timer functions.
Note: Clock must be set in order to use
Timers.
17-I. ALARM
Gives you the option of making the alarm
function available to the user. Set to 1,
Alarm function is available to user. Set to 0
to disable the Alarm function.
Note: Clock must be set in order to set the
Alarm.
18-I. NOT USED
19-I. NOT USED
20-I. FEATURE LEVEL
Default set to ZEN 1 for Zenith IR remote
control operation. Set O, P LBL for Zenith
Private Label IR remote control operation.
Warning:
Do not change the default value
unless you have the proper
remote controller to operate the
TV.
21-I. V-CHIP
Set to 1 to activate V-Chip (Parental
Control); have it available to user to filter or
control or restrict programming content. Set
to 0 to turn V-Chip feature off, not available
to user; no programming restrictions can be
set.
22-I. MAX BLK HRS
Set 0 to 99 for the maximum V-Chip
(Parental Control) block hours. Default
setup is 12 blocking hours.
23-I. CAPTION LOCK
Set to 1 to restore previous Caption On/Off
state after TV turns off. When set to 0,
Captions are always off, when TV is initially
turned on.
24-I. TEXT MODE
Determines whether TEXT 1, TEXT 2,
TEXT 3, or TEXT 4 decoding is enabled
when TEXT is turned on (either from the
Setup Menu or directly with CC on the
remote).
TIP: Set Text Mode to 1 only if text is
offered in your video system.
25-I. FUNCTION PRE.
Set to 0 to suppress CHANNEL PREVIEW
from the FUNCTION menu with some Pay-
Per-View systems.
26-I. NOT USED
27-I. NOT USED
28-I. CH. OVERRIDE (Channel Override)
When set to 1, the user can select channels
with either Channel Up/Down or by direct
keypad entry. When set to 0, only those
channels that are entered for scanning may
be selected by direct keypad entry. Note: If
set to 0, Auto Program is locked; (as shown
on Setup menu) channel search is not
available.
29-I. OLD OCV (On Command VideoTM)
Set to 1 for operation with systems from On
Command Corporation.
30-I. ACK MASK
M.P.I. Communication Parameter. Leave at
default setting unless changed by Pay-Per-
View provider.
31-I. POLL RATE
M.P.I. Communication Parameter. Leave at
default setting unless changed by Pay-Per-
View provider.
32-I. TIMING PULSE
M.P.I. Communication Parameter. Leave at
default setting unless changed by Pay-Per-
View provider.
Page 43
Advertisement
Table of Contents
