Warranty; Know Your Unit; Assembly Instructions - Craftsman WEEDWACKER INCREDI-PULL 316.791020 Operator's Manual

FOR 2 YEAR(S) from the date of purchase, this product is warranted against any defects in material or workmanship. Defective product will receive free repair
or free replacement if repair is unavailable.
For warranty coverage details to obtain repair or replacement, visit the web site: www.craftsman.com
This warranty covers ONLY defects in material and workmanship. Warranty coverage does NOT include:
Expendable items that can wear out from normal use within the warranty period, such as line, fi lters, or spark plugs.
•
Product damage resulting from user attempts at product modifi cation or repair or caused by product accessories.
•
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
•
Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
•
This warranty is void if this product is ever used while providing commercial services or if rented to another person. This warranty gives you specifi c legal
rights, and you may also have other rights which vary from state to state.
Sears Brands Management Corporation, Hoffman Estates, IL 60179
APPLICATIONS
As a trimmer:
Cutting grass and light weeds.
•
Edging
•
Decorative trimming around trees, fences, etc.
•
Other optional accessories may be used with this unit.
Cutting Head
INSTALL CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting
attachment shield on the unit is not installed.
Use only the instructions that apply to the
type of shaft and shield that the unit is
equipped with.
1. Place the cutting attachment shield onto
the shaft housing. Be sure the guard
mounting bracket slides into the slot on
the edge of the cutting shield. Rotate
the shield into place, counterclockwise
(Fig. 1). The holes in the guard mounting
bracket and cutting attachment shield will
line up.
2. From inside the cutting attachment shield,
push the square bolt through the hole until
the threaded end protrudes through the
guard mounting bracket (Fig. 2).
3. Put the washer on the bolt, then screw the
wing nut onto the bolt and tighten.
4

WARRANTY

CRAFTSMAN 2 YEAR FULL WARRANTY

KNOW YOUR UNIT

On/ Off Switch
D-Handle
Convertible™
Coupler
Shield

ASSEMBLY INSTRUCTIONS

INSTALL AND ADJUST THE D-HANDLE
Mount
Shield
Bracket
1. Push the D-handle down onto the shaft
2. Insert the the bolt into the hex hole in
Fig. 1
Square Bolt 3. Rotate the D-handle to place the grip above the top of the shaft housing.
Washer
4. While holding the unit in the operating position (Fig. 11), move the
5. Tighten the wing nut until the D-handle is secure.
Wing Nut
Fig. 2
Spark Plug
Muffl er
Starter Rope
Grip
Fuel Cap
Throttle Control
housing (Fig. 3). The hex bolt hole in the
handle should be on the left side.
the handle and push through. Place the
washer on the bolt, then screw the wing
nut onto the bolt. Do not tighten until
making the handle adjustment.
Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.
D-handle to the location that provides the best grip.
Air Cleaner
Choke Lever
Primer Bulb
Grip D-Handle
Wing
Nut
Min. 6 in.
(15.24 cm)
Washer
Bolt
Fig. 3