Installation - Tripp Lite B110-SP-10G Quick Start Manual

Installation

Note: The following instructions assume that two network devices are
currently connected together.
Single Device Protection:
1. Disconnect the installed patch cable from the device you wish
to protect and attach it to the "Cable End" of the In-Line 10G
Network Surge Protector.
2. With a user-supplied Cat5/5e/6/6a/8 patch cable, connect the
device to be protected to the "Equipment End" of the In-Line
10G Network Surge Protector.
Note: For best protection performance, the patch cable between
the "Equipment End" on the B110-SP-10G and the equipment
to be protected should not exceed 330 ft. (100 m). Tripp Lite's
N261-Series Cat6a Snagless Patch Cables are recommended.
3. Connect the ground wire to the In-Line 10G Network Surge
Protector and then to earth ground.
3