W_Flow1: Water Flow Meter Connector; Jln1: Low Temperature Booting Jumper - MSI MEG X670E GODLIKE User Manual

W_FLOW1: Water Flow Meter Connector

This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.

JLN1: Low Temperature Booting Jumper

This jumper allows liquid nitrogen cooling system to boot at an extremely low
temperature. Please try to enable the jumper to help the system boot successfully.
⚠
Important
∙ Please note that overclocking at an extremely low temperature carries the risk of
system instability and may cause damages to the system.
The overclocking results may vary depending on the CPU you use.
∙
∙ Do not enable the jumper when the system is power off. Otherwise, the system will
be unbootable.
Pin Signal Name
1 Ground
3 WFLOW IN
Normal
(Please enable this jumper
(Default)
50
1
Pin Signal Name
2 WFLOW PWR
Enabled
during BIOS POST)