Power Button - Chevrolet Spark 2022 Owner's Manual

116 Driving and Operating
During the running-in period fuel and engine
oil consumption may be higher.

Power Button

Electronic key must be inside the vehicle.
Accessory power mode : press Engine Start/
Stop button once without operating clutch
or brake pedal. The yellow LED in the button
illuminates. Steering wheel lock is released
and some electrical functions are operable,
ignition is off.
Ignition on power mode : press and hold
Engine Start/Stop button for 6 seconds
without operating clutch or brake pedal. The
green LED in the button illuminates, diesel
engine is preheating. Control indicators light
up and the most electrical functions are
operable.
Engine start : operate clutch pedal (manual
transmission) press Engine Start/Stop button
once more. Release button after starting
procedure begins.
Ignition off : press Engine Start/Stop button
briefly in each mode or when engine is
running. Some functions remain active until
driver's door is opened, if ignition was on
before.
Steering wheel lock
The steering wheel lock activates
automatically when:
the vehicle is stationary and
the ignition has been switched off and
the driver's door is opened.
To release steering wheel lock, open and
close driver's door and switch on accessory
mode or start the engine directly.
Warning
If the vehicle battery is discharged, the
vehicle must not be towed, tow-started
or jump-started as the steering wheel
lock cannot be disengaged.
Emergency operation on vehicles with
electronic key system
If either the electronic key fails or the
battery of the electronic key is weak, the
Driver Information Centre may display Key
when you try to start the vehicle. Vehicle
Messages 0 81.