Troubleshooting - Homelite UT41122 Operator's Manual

 Pull the strings extending from the string head so the line
releases from the slots in the spool.
 Reinstall the spool retainer by depressing tabs into slots and
pushing down until spool retainer clicks into place.
LINE REPLACEMENT
See Figures 15 - 16.
 Unplug the string trimmer.
 Remove the spool from the string head.
NOTE: Remove any old line remaining on the spool.
 Cut two pieces of line, each being approximately
9 ft. long. Use only .065 in. diameter monofilament line.
 Insert the first line into the anchor hole in the upper part of
the spool. Wind the first line around the upper part of the
spool clockwise, as shown by the arrows on the spool. Place
line in the slot on spool, leaving about 6 in. extended beyond
PROBLEM
Lines will not advance when using the
Auto Feed Head:
Grass wraps around driveshaft housing
and string head:
Motor fails to start when switch trigger
is depressed.
This product has a Two-year Limited Warranty for personal, family, or household
use (90 days for business or commercial use). For warranty details, visit
www.homelite.com or call (toll free) 1-800-242-4672.
MAINTENANCE
 Repeat above step with second line, using the bottom part
 Replace the plastic retainer, spool, and the spool retainer.
STORING THE TRIMMER
 Unplug the string trimmer.
 Depress telescoping boom coupler and set at shortest
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden chemicals

TROUBLESHOOTING

POSSIBLE CAUSE
1. Lines are welded to themselves.
2. Not enough line on spool.
3. Lines are worn too short.
4. Lines are tangled on spool.
1. Cutting tall grass at ground level.
1. Power cord is not plugged in or
connection is loose.
2. Household circuit breaker is tripped.
Page 9 — English
the slot. Do not overfill. After winding the line, there should
be at least 1/4 in. between the wound line and the outside
edge of the spool.
of spool. Do not overfill.
Refer to Spool Replacement earlier in this manual.
setting.
and de-icing salts.
1. Lubricate with silicone spray.
2. Install more line. Refer to Line
Replacement earlier in this manual.
3. Pull both lines while pressing button.
4. Remove lines from spool and rewind.
Refer to Line Replacement earlier in
this manual.
1. Cut tall grass from the top down to pre-
vent wrapping.
1. Plug in the power cord.
2. Check circuit breaker.
SOLUTION