How To Check Overlapping Of Central Address No - Sanyo ECO-i AHX0752 Technical Data Manual

4. System Controller

How to check overlapping of central address No.

(1) Press the
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C3 by pressing
( ) button and press the
C3 changes from flashing to ON state and
will flash. Then auto. overlap checking will start .
(3) If C3 changes from ON to flashing and
stops flashing and disappears, there is no over-
lapping.
Then finally, complete the auto overlap checking
mode by pressing the
(4) If some of GROUP No., ZONE No. and UNIT No.
flash, you should try again the zone registration.
1 Select CODE No. C1 by pressing
1
( ) button and press the
2 Select the flashing GROUP No. with ZONE
and GROUP button.
Then press the
ZONE, GROUP and UNIT No.
2
3 Then finally, complete the auto. overlap
checking mode by pressing the
3
4
5
6
7
8
and buttons at the same
ZONE
button.
button.
button and reselect the
button.
,
,
button.
3-58
Control of W-3WAY ECO-i SYSTEM
ZONE 1 2 3 4 6
ZONE
9
GROUP
SELECT ZONE
Fig. 3-39
2054_M_I