Removing And Refitting The Door Panels; Oven Door - Additional Safety Precautions; Troubleshooting; Malfunction Table - Bosch HGV74W356T Instruction Manual

Free standing cooker
Table of Contents

Advertisement

Removing and refitting the door panels

The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards.
Remove the cover from the top of the oven door. To do this,
2.
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).
Raise the top panel and pull it out (Fig. B).
3.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting
Hold the top glass panel firmly by the sides and slide it in
1.
towards the back at an angle. The panel must be inserted

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
The clock dis-
Power cut
play flashes.
The oven does
There is dust on
not heat up.
the contacts.
The gas burner
Power failure or
does not ignite.
damp ignition
plugs.
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Light the gas burner with a
gas lighter or a match.
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
Place the cover on the top of the oven door and press in
2.
place. Make sure that the grooves along the sides lock into
position.
Refitting the oven door See the section Refitting the oven
3.
door.
Do not use the oven again until the panels have been
correctly fitted.

Oven door - Additional safety precautions

During long cooking times, the oven door may become very
hot.
If you have small children, extra supervision is required during
oven operation.
In addition, there is a protective device (protective grid) which
prevents direct contact with the oven door. You can purchase
this optional accessory (469088) from the after-sales service.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.
19

Advertisement

Table of Contents
loading

Table of Contents