Rf Safety Information; Technical, Support And Warranty Information Technical, Support And Warranty Information - Zte EasyTouch Discovery 2 User Manual

Hsdpa multi band 3g mobile phone
Table of Contents

Advertisement

RF Safety Information

The handset has an internal antenna located in the top of the phone. For optimum performance with
minimum power consumption do not cover the antenna area with your hand. Hold the handset between
thumb and finger in the middle of the device. Covering the antenna affects call quality, may cause the
handset to operate at higher power levels than needed, and may shorten talk and idle times.
The handset is a low-power radio transmitter and receiver. When switched on it intermittently transmits
radio frequency (RF) energy (radio waves). The transmit power level is optimized for best performance and
automatically reduces when there is good quality reception. Maximum power is only used at the edge of
network coverage so under most circumstances the power output is very low. Under poor network condi-
tions the phone transmits at a higher power, may get hot and have a significantly shorter battery life.
Interference with Pacemakers and other Medical Devices
Interference with Pacemakers and other Medical Devices
Interference with Pacemakers and other Medical Devices
Interference with Pacemakers and other Medical Devices
Interference with Pacemakers and other Medical Devices
Your mobile phone may cause interference with pacemakers, hearing aids and other medical devices. Inter-
ference may be caused by transmitted radio signals when the phone is held in close proximity to the device
or in direct contact with the skin. It is important to note that any interaction between the mobile phone and
the device is temporary. Moving the phone away will restore the device to its correct operation.
Declaration of Conformity – SAR (Specific Absorption Rate)
Declaration of Conformity – SAR (Specific Absorption Rate)
Declaration of Conformity – SAR (Specific Absorption Rate)
Declaration of Conformity – SAR (Specific Absorption Rate)
Declaration of Conformity – SAR (Specific Absorption Rate)
We declare that the product(s) detailed in this manual, and in combination with our accessories, conform
with the essential requirements of The Radio Communications Standard (Electro-magnetic Radiation Hu-
man Exposure) 2003 and the Australian Communications & Media Authority Section 376 of the Telecommu-
nications Act 1997.
N 1 4 9 4 5
N 1 4 9 4 5
N 1 4 9 4 5
N 1 4 9 4 5
N 1 4 9 4 5
9

Advertisement

Table of Contents
loading

Table of Contents