Epson Mobilink TM-P20II Technical Reference Manual page 76

Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure.
1
Load paper in the printer, and then turn it on.
• Make sure no errors have occurred and that the printer is not off-line.
• You cannot pair the printer while the network is starting up immediately after the power is
2
Open the roll paper cover, hold down the FEED button (two seconds), and then close
the roll paper cover.
A guidance that starts with "Next Action" will be printed.
3
Briefly press the Feed button (less than one second), and then hold down the button
for at least one second.
4
A status sheet is printed, and the Bluetooth LED flashes a pattern indicating that pair-
ing is now possible.
After this, the printer will be able to be paired for one minute only.
You can enable pairing also by printing the status sheet by pressing the status sheet button.
Pairing method when the security is set to High (from the host)
When the security is set to High and the printer is ready to be paired, perform the following procedure.
1
Search for the printer on the Bluetooth settings screen on the host device.
2
Select the printer you want to pair with.
The printer prints the Passkey.
3
Check that the printed Passkey and the Passkey displayed on the host device match,
and then select "Pairing" on the host device.
Bluetooth communication interval during power saving mode (Bluetooth
model)
Select [Bluetooth Setup] and then [Low Power Level] to change the communication interval when waiting to
receive data from the host in power saving mode.
• Level 1 (Standard) (initial setting)
• Level 2 (Short)
turned on.
Chapter 4 Advanced Usage
76