• If the red DRIVE LED is not ON with AC power up, press the PGRM / DRIVE key until the red Drive LED is ON. The Inverter is now in the RUN mode. _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 3
The method of control is set by parameter Sn – 04. The table on the next page shows the value • that Sn – 04 needs to be set for the various combinations of control. _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 4
In the following pages are wiring examples for Start / Stop, E-Stop, Restart, and Analog Connections. Danger After the power has been turned OFF, wait at least 5 minutes until the charge indicator extinguishes completely before touching any wiring, circuit boards, or components. _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 5
The Fault may be also use of the Fault contacts. flashing lamp or reset from the keypad. They could also be used to buzzer shut down equipment etc. FAULT RESET SWITCH _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 6
0 - +10 VDC INPUT VOLTAGE SOURCE Fig. 3b 4 – 20 mA Analog Input Connect shield to terminal E Shielded twisted Pair 4 – 20 mA 4 – 20 mA INPUT CURRENT SOURCE _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 7
Pump application. More detailed information is available in the PA7300 Manual to which the user is referred, if further information is required. _______________________________________________________________ TECO – Westinghouse Motor Company...
Page 8
Key; The display should read Press the Key to save. Press the to return to the main display. Appendix B - Removing the LCD Digital Operator and Inverter Cover(s) _______________________________________________________________ TECO – Westinghouse Motor Company...