Heat & Glo CMOD-36-GY Installation Instructions

CMOD-36-GY, CMOD-42-GY, CMOD-36-BK, CMOD-42-BK Doors
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed under a surround.
CONTENTS:
(1) Decorative Front
(4) Shoulder Bolts
Verify and remove contents from packaging before begin-
ning installation.
INSTALLATION
1. Install the shoulder bolts by threading the bolts into the
rivnuts. See Figure 1.
2. Bend the (4) handbend J-hooks on the back of the inner
door to 90° perpendicular to allow for easy hanging of
the door on the unit. Adjust handbend J-hooks if needed.
See Figure 2 for reference.
1
Models: 6000CMOD-IPI, 8000CMOD-IPI Door
- Installation Instructions -
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
Heat & Glo • CMOD-36 and CMOD-42 Door Instructions • 2241-946 Rev. B • 11/14
TOP
SHOULDER
BOLTS
BOTTOM SHOULDER
BOLTS
Figure 1. Shoulder Bolt installation
3. Attach the inner door to the appliance, mount the J-hooks
on the shoulder bolts. See Figure 2.
90° HARDBEND J-HOOK
Figure 2. Inner Door Installation