Quality Espresso FUTURMAT SENSIUS GOLD Operating Instructions Manual page 24

Note:
Before programming the different coffee doses:
 Make sure the grind fineness and amount of coffee are correct.
 Also check that the pump is correctly adjusted to a 9 bar pressure, making coffee on one group head.
To view the pump pressure, check the gaugelocated on the lower front part of the machine to the left
and see what the pressure needle to the left marks.
If necessary, adjust the pump using the bypass (the pump is located inside the machine, to the left).
To access it you will need to remove the lef thand panel of the machine.
3.3 Coffee dose programming
1. Entering the programming mode
2. Programming the dose
3. Exiting the programming mode
1. Entering the programming mode
1.1 Switch the machine off by means of the main switch.
1.2 Turn on the machine with the main switch and wait until the long coffee button from group 1 (left touch
button) goes out. Then immediately press the continuous Coffee button from group 1 (left touch but-
ton) and hold it down until all of the buttons' lights are steady.
2. Programming the dose
2.1 Press and hold the beverage button that you want to program in group head 1 until the coffee dispen-
ser is activated.
2.2 Wait until you have obtained the required dose and press the same button to stop the dispensing.
2.3 Repeat points 2.1 and 2.2 for all the programmable buttons in the left group head.
Note:
By only programming group head 1 (left), all the other groups will be automatically programmed when
exiting the programming.
If you want in any group different doses to those programmed in group head 1, continue programming by
repeating points 2.1, 2.2 and 2.3 for the group heads in which you want different doses, before finally exi-
ting the programming.
3. Exiting the programming mode
3.1 Turn the machine off and on with the main switch.
24
Figure 1