Quality Espresso FUTURMAT SENSIUS GOLD Operating Instructions Manual page 19

Electrical
connection
Handling
Note: this device does not exceed 70 dB of sound pressure
Check that all the electrical connection characteristics comply

with the voltage, frequency and power indications described on
the machine specifications plate. The specifications plate is
located on the chassis underneath the drainage tray.
We consider that the machine has been correctly installed

when it has been connected using an all-pole magnetic circuit
breaker appropriate to the power of the machine, and with an
RCD with a residual current that does not exceed 30 mA.
The machine must be installed according to the current elec-

trical regulations of the place of installation. You must ensure
that the electrical installation is reliably grounded in accord-
ance with the above-mentioned regulations. Quality Espresso
does not accept any responsibility for any injuries caused by
faulty installation or grounding connection.
You must not use any type of extension cords or power strips

to connect the machine to the power supply. The power con-
nection cable should never be rolled up, but instead should be
fully extended to prevent possible overheating.
Any internal handling of the machine must be carried out by

an authorised technical service.
Cleaning and preventive maintenance must be carried out

according to the frequency indicated for the machine or tech-
nical service.
The manufacturer does not accept any responsibility for any

damage to the machine as a result of failing to comply with
the said obligations, or any damage from incorrect or improp-
er use of the machine.
All machine components, including the power cable, should

only be replaced with original spares. If the power cable is
damaged, it must be replaced by the manufacturer, their after
-sales service or similar qualified personnel to prevent any
hazards.
Before carrying out any maintenance work, disconnect the

machine from the electrical supply either through the main
switch or by disconnecting the power cable.
19
EN