Roland PX-7B Service Notes page 5

Oct. 2013
Installing the Circuit Board
1.Peel off the backing paper of all the double-sided adhesive tape on the circuit board.
2.Align the notch of the circuit board with the tab on the sub-chassis and press the circuit board to the depth of the notch.
3.First, fasten with screws in the round holes.
Set the round holes in the circuit board on the center of the screw holes in the sub-chassis and secure in place.
4.Fasten screws in the slotted holes.
fig.PWB-set-1-e.eps
#40011312: P-TITE BIND 3X8
Sandwich the circuit board.
Position using the notch.
Press in until flush.
PX-7B, PX-7C
5