This service note contains information about repair parts and the repair method of the keyboard section. For other sections of each model, please refer to each service note. Table of Contents Keyboard Parts List (PX-7B) ..........2 Keyboard Parts List (PX-7C)..........3 Keyboard Assembly Procedure ........4 Circuit Board (Low, Mid)..........9...
Oct. 2013 PX-7B, PX-7C Keyboard Parts List (PX-7B) fig.key-PX-7B.eps Part Code Part Name Description Q’ty 5100034009 KEYBOARD ASSY PX-7B 5100016416 N-KEY C PX-7 (C6200269R0) 5100016417 N-KEY D PX-7 (C6200270R0) 5100016418 N-KEY E PX-7 (C6200271R0) 5100016419 N-KEY F PX-7 (C6200272R0) 5100016420...
Oct. 2013 PX-7B, PX-7C Keyboard Parts List (PX-7C) fig.key-PX-7C.eps Part Code Part Name Description Q'ty 5100053166 KEYBOARD ASSY PX-7C SV SERVICE ASSY 5100054674 5100046363 N-KEY C PX-7C 5100046364 N-KEY D PX-7C 5100046365 N-KEY E PX-7C 5100046366 N-KEY F PX-7C 5100046367...
Oct. 2013 PX-7B, PX-7C Keyboard Assembly Procedure Removing the Key Insert the tip of needle nose pliers into the U-groove on the pivot side and push in the direction of arrow A. *Before removing black keys, first be sure to remove the adjacent white keys.
Page 5
Oct. 2013 PX-7B, PX-7C Installing the Circuit Board 1.Peel off the backing paper of all the double-sided adhesive tape on the circuit board. 2.Align the notch of the circuit board with the tab on the sub-chassis and press the circuit board to the depth of the notch.
Page 6
Oct. 2013 PX-7B, PX-7C Application of Grease Greasing Points After the key or hammer has been replaced, the specified grease must be applied to the following points as shown in the figure. fig.key-grease.eps 1-(b) 2-(a) 1-(c), 2-(b) 1-(a) 1.MORICOAT G-1039...pink (#17041858)
Page 7
Oct. 2013 PX-7B, PX-7C Regarding Hammer Placement Hammers that have differently shaped metal and plastic portions are arranged as shown in the figure below. When replacing, be very careful not to position the hammers incorrectly. *Installation at an incorrect location may impede key touch.
Page 8
Oct. 2013 PX-7B, PX-7C Affixing the Cushion The cushions are of five types. Position each according to the instructions in the figure. fig.key-cushion-e.eps #5100019110 or #5100048726: #5100028252 or #5100048727: KEY CUSHION A (white) KEY CUSHION E (white) Position flush against the edge Align with the edge of the Guide Holder.