Advertisement
GAMMA instabus
Technical Product Information
August 2013
Binary input device N 262E11
16x potential-free contacts
Attaching the bus terminal (Figure 3)
Insert the bus terminal (D2) into the guide slot and press
the bus terminal backwards until it reaches the stop posi-
tion.
Figure 3: Attaching / removing the bus terminal
Mounting the insulating cap
If the device is to be mounted on a DIN rail without a
data rail, then the contact system must be covered using
the supplied insulating cap.
Removing the locating clamp (Figure 4)
The locating clamp (E3) encloses the contact system
-
(E2) on the rear of the device (E1).
Insert the screwdriver between the DIN rail mounted
-
device (E1) and the locating clamp (E3) and remove
the clamp.
Clipping on the insulating cap (Figure 4)
Place the insulating cap (E4) on the contact system and
-
press so that it snaps into place.
E3
E1
E2
Figure 4: Covering the contact system
Technical Manual
Update: http://www.siemens.de/gamma
2.7.4.2/4
D
2
D2.3
D2
D2.1 D2.2
D2.4
D2
D1
5 mm
D2
D2.4
E2
E4
E1
N 262E11, 4 pages
Siemens AG 2013
Subject to change without further notice
Dimension drawing
Dimensions in mm.
b
b = 6 module units
1 module unit (MU) = 18 mm
General notes
The operating instructions must be handed over to the
client.
Any faulty device is to be sent together with a return de-
livery note of the local Siemens office.
If you have further questions concerning the product
please contact our technical support.
Technical Support
+49 (911) 895-7222
+49 (911) 895-7223
support.automation@siemens.com
www.siemens.de/automation/support-request
Infrastructure & Cities Sector, Building Technologies
P.O. Box 10 09 53, D-93009 Regensburg
5WG1 262-1EB11
44
55
Siemens AG
Control Products and Systems
Advertisement
