Download Print this page

Advertisement

Quick Links

RECOMMENDATIONS AND SUGGESTIONS
The Instructions for Use apply to several versions of this appliance. Accordingly, you may find
descriptions of individual features that do not apply to your specific appliance.
INSTALLATION
• The manufacturer will not be held liable for any damages resulting from incorrect or improper
installation.
• The minimum safety distance between the cooker top and the extractor hood is 650 mm (some
models can be installed at a lower height, please refer to the paragraphs on working dimensions
and installation).
• Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of
the hood.
• For Class I appliances, check that the domestic power supply guarantees adequate earthing.
Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route
of the flue must be as short as possible.
• Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces,
etc.).
• If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a
sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of
exhaust gas. The kitchen must have an opening communicating directly with the open air in order
to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances
supplied with energy other than electric, the negative pressure in the room must not exceed 0,04
mbar to prevent fumes being drawn back into the room by the cooker hood.
• In the event of damage to the power cable, it must be replaced by the manufacturer or by the
technical service department, in order to prevent any risks.
• If the instructions for installation for the gas hob specify a greater distance specified above, this has
to be taken into account. Regulations concerning the discharge of air have to be fulfilled.
USE
• The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
• Never use the hood for purposes other than for which it has been designed.
• Never leave high naked flames under the hood when it is in operation.
• Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not
engulf the sides.
• Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
• Do not flambè under the range hood; risk of fire
• This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given su-
pervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• " CAUTION: Accessible parts may become hot when used with cooking appliances.".
MAINTENANCE
• Switch off or unplug the appliance from the mains supply before carrying out any maintenance
work.
• Clean and/or replace the Filters after the specified time period (Fire hazard).
• Clean the hood using a damp cloth and a neutral liquid detergent.
The symbol
on the product or on its packagi n g indi c ates that this product may not be treated as househol d waste. Instead i t shall be handed over to the
appl i cabl e coll e cti o n point for the recycli n g of electrical and electroni c equi p ment. By ensuri n g thi s product i s disposed of correctl y , you wi l l hel p prevent potenti a l negati v e
consequences for the envi r onment and human health, whi c h could otherwise be caused by inappropriate waste handli n g of this product. For more detai l ed informati o n
about recycli n g of this product, pl e ase contact your l o cal ci t y office, your househol d waste disposal service or the shop where you purchased the product
EN
Questo manuale d'istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per
tuo prodotto tra le
migliori offerte di Cappe da Cucina
.
Smeg KE61XE
o cerca il
1 10

Advertisement

loading

Summary of Contents for Smeg KE61XE

  • Page 1 Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Smeg KE61XE o cerca il tuo prodotto tra le migliori offerte di Cappe da Cucina RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance.
  • Page 2 CHARACTERISTICS - INSTALLATION FIXING OF THE HOOD UNDER THE CABINET • To drill the cabinet follow the indications given in the dimen- sional drawing in the chapter which regards hood dimensions. • To fix the hood onto the cabinet use the 44,4 mm long screws inserting and tightening them from the inside of the cabinet.
  • Page 3: Electrical Connection

    AIR OUTLET IN THE RECYCLING MODE • Open the metal grid and make sure that the conver- sion knob is in the recycling position. • Place the charcoal filter. The charcoal filter is not supplied together with the hood. (Hoods with two motors needs to be equipped with two charcoal fil- ters).
  • Page 4 Light Switches the lighting system on and off Speed Sets the operating speed of the extractor: 0. Motor Off. 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. 2. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio.
  • Page 5: Maintenance

    MAINTENANCE GREASE FILTER Regular maintenance and cleaning will ensure good performance and reliability, while extending the working life of the hood. Spe- cial attention should be taken to keep the grease filter clean at all times and the charcoal filter (recirculation model) should be re- placed regularly.
  • Page 6: Worktop Illumination

    WORKTOP ILLUMINATION If a lamp fails to function at any time, open the metal grille panel and check that the lamp is fully screwed into the holder. When changing the lamp, an identical replacement must be fitted to ensure a safe working of the hood. CLEANING The metalwork should be cleaned regularly, at least once a month, using household cleaners and polish.