Kurzweil K2600 Install Manual page 2

Rack and keyboard p/ram-26 program expansion module

Hide thumbs Also See for K2600:

Installation For Rack Units

Warning:

Unplug all external wires, cables, and connectors from the K2600R and turn the unit upside down.

Locate the access panel on the bottom side of the unit. Using a #2 Phillips screwdriver, remove the

six screws attaching the access panel. Set the access panel and screws aside for reassembly.

Locate the P/RAM placeholder card (in the socket labeled J803, as shown in Figure 1). Remove the

placeholder card and set aside.

Insert the P/RAM Expansion Module into J803. The board is keyed so that it can go in only one

way. Note: on your instrument, socket J803 may be labeled PRAM3.

Replace the access panel and loosely install the screws, starting with those closest to the hinge

(back) of the access panel. When the screws are loosely in place, tighten them all.

Reconnect the power to the K2600R, then check the amount of program RAM by entering Disk

mode and viewing the amount of available RAM shown in the top line of the display. There

should be approximately 1500K of available RAM. This completes the installation of the

P/RAM Expansion Module.

Installation For Keyboard Units

Warning:

Unplug all external wires, cables, and connectors from the K2600 and turn the unit so the

keyboard faces you.

Turn the keyboard upside down onto a soft surface, resting the front panel on two thick foam

pads; these pads will prevent damage to the K2600Õs sliders and alpha wheel.

Using a #2 Phillips screwdriver, remove the eight screws attaching the access panel. Set the access

panel and screws aside for reassembly.

Locate the P/RAM placeholder card (J803, as shown in Figure 1). Remove the placeholder card

and set aside.