Table of Contents
Advertisement
2.16
Device Operation
The Web Monitor facilitates the displaying of parameters, indications and measuring values for 7SC80 devices
during operation or commissioning. The Web Monitor is called via a web browser such as the Internet Explorer.
Apart from general information regarding installation, this manual provides a description of specific functions of
the Web Monitor for 7SC80 only. The general functions are described in the Help file of the DIGSI CD (from
DIGSI V4.60 on).
Prerequisites
The Web Monitor runs on the operator PC and requires only standard software. The following software / oper-
ating systems must be installed:
Operating system: Microsoft Windows XP or Windows 7
Internet browser: Microsoft Internet Explorer from Version 7.0 on or other browsers which can start JNLP files,
e.g. Mozilla Firefox.
Java Runtime Environment (JRE) from Version 6 on must be installed and activated.
Network adapter: The required software component is included in Microsoft Windows. This component is only
required if the device is connected via an Ethernet interface (possible for devices with EN100 interface).
2.16.1
Web Monitor
General
To run the Web Monitor, the operator PC must be connected to the Feeder Automation Controller 7SC80 via
the Ethernet interface. If you want to use the USB interface, a data communication connection is required. In-
formation on configuring the data communication connection is available on the Internet at www.siprotec.de.
An Internet browser must be installed on the operator PC (see paragraph on system requirements). DIGSI 4 is
usually also installed on the operator PC.
Note that DIGSI 4 and the Web Monitor do not work on the same interface at the same time.Before the Web
Monitor is started, the settings and routings on the device should have been completed with DIGSI 4.
The Web Monitor is included in the Feeder Automation Controller 7SC80 delivery. It consists of HTML pages
and a Java web start application, which are stored in the 7SC80. It forms an integral part of the firmware and
therefore does not need to be installed separately.
To start the Web Monitor:
• Open the Internet browser.
• Enter the IP address of the used interface of the 7SC80 in the address bar of the browser.
The basic window of the Web Monitor is displayed. It shows the following areas:
• Navigation tree for selecting the output of indications and measured values
• Control and display panel
Via the menu bar, you can select all logs and measured values displayed in the navigation tree.
The menu item Options is used for diagnostic purposes and can be activated by Siemens experts only.
SIPROTEC, 7SC80, Manual
E50417-G1140-C486-A1, Release date 12.2011
Functions
2.16 Device Operation
185
Advertisement
Table of Contents
