ProCurve J8451A Quick Start Manual

Quick Start Guide
ProCurve Secure Router dl 1xT1 Module
J8451A
S
PECIFICATIONS
Operating T1/FT1 Frame Relay, T1/FT1 PPP, T1/FT1 HDLC,
Modes T1/FT1 Multilink Frame Relay, T1/FT1 Multilink PPP
T1/FT1 Supported Standards: AT&T TR 62411, AT&T TR 54016,
Interface ANSI T1.403, Bellcore TR 194
Line Rate: 1.544 Mbps ±75 bps
Line Code: AMI or B8ZS
Framing: D4 (SF) or ESF
FT1 Line Rate: DS0 channelized
Input Signal: 0 to -36 dB (DS1)
Line Build-Out: 0, -7.5, -15, -22.5 dB or 0 to 655 feet
Connector: RJ-48C
DS0 Assignment: Programmable
Clock Source Network, internal
Diagnostics Test Pattern Generation and Detection: QRSS, 511,
all ones, all zeros
Network loopbacks (local and remote); responds to both
inband and FDL loop codes
Alarm generation and detection
Network and user sets of performance data
(15 minutes and 24 hours)
Compliance FCC Part 15 Class A, EN 55022 Class A
ACTA/FCC Part 68, IC CS-03
UL/CUL 60950, IEC 60950
Physical Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D
Operating Temperature: 0°C to 50°C (32°F to 122°F)
Relative Humidity: Up to 95 percent, noncondensing at
30°C (86°F)
Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)
Non-Operating Relative Humidity: Up to 95 percent,
noncondensing at 30°C (86°F)
Altitude: Up to 3.048 km (10,000 ft)
61195862L1-13D, May 2006
5990-8885
I I
NSTALLATION
For ProCurve Secure Router modules with outside plant
Warning
connections, ensure that all cables are removed from the
module before installing or removing it from the router
chassis.
1. Remove power from the unit.
2. Slide the ProCurve Secure Router dl 1xT1 Module into the option slot
until the module is firmly seated against the chassis.
3. Secure the screws at both edges of the module.
4. Connect the cables to the associated device(s).
5. Complete the installation of the base unit.
6. Restore power to the unit.
For safety information for the routers and all modules,
Note
please refer to the safety and ESD precautions in the
ProCurve Secure Router Installation Guide included
in your router shipment.
T1 N (RJ-48C) C
ETWORK
Pin Name
1 R1
2 T1
3 —
4 R
5 T
6-8 —
An optional backup module is required for backup
Note
applications.
For a description of the backup connection pinouts,
refer to the Quick Start Guide included with your
backup module
www.procurve.com
NSTRUCTIONS
ONNECTION
Description
Receive data from the network
Receive data from the network
Unused
Transmit data toward the network
Transmit data toward the network
Unused
Copyright 2006 Hewlett-Packard Development Company, LP
P
INOUT