ProCurve 7102dl Quick Start Manual

Quick Start Guide
ProCurve Secure Router 7102dl
J8752A
ProCurve 7102dl
Slots
Secure Router
1
J8752A
Stat
Bkp
Power
Tx
Rx
Console
Fault
I I M
NSTALL THE NTERFACE ODULE
1. Verify the unit is not connected to a power source.
2. (Optional) To install the backup module, carefully align the P1 connector on the interface
module with the J1 connector on the backup module. Using only fingertip pressure to
ensure that neither circuit board bends or flexes, firmly seat the connectors. Secure the
backup module to the interface module using the supplied screws and standoff posts.
3. Slide the interface module into the option slot until the module is firmly positioned
against the chassis.
4. Secure the screws at both edges of the module.
G R
ROUND THE OUTER
1. Strip one end of the ground wire to the length required for the ring terminal. (Ground wire
and ring terminal are supplied by the user. For more detailed grounding specifications,
please refer to the ProCurve Secure Router Installation Guide.)
2. Crimp the ground wire to the ring terminal, using a crimp tool of the appropriate size.
3. Attach the ring terminal to the chassis as shown in the figure to the right.
4. Connect the other end of the ground wire to a suitable grounding point at your site.
5. Apply power to the unit.
For information on installing the Encryption and Compact Flash modules
Note
please refer to the ProCurve Secure Router Installation Guide included in
your router shipment.
61195880L1-13C, August 2005
Eth 0/2
2
Stat
Bkp
Tx
Rx
Eth 0/1
dl dl
C
ONNECT TO THE
Before connecting to the ProCurve Secure Router 7102dl Console interface you will need the
following items: VT100 terminal or PC (with VT100 terminal emulation software) and the serial
cable (5184-1894) supplied with your router. (This is the same console cable used in other
ProCurve switches such as the 5300xl series.)
1. Connect the DB-9 (female) connector of your cable to the DB-9 DTE (male) Console
interface on the front panel of the unit.
2. Connect the loose end of the cable to the VT100 terminal or PC (with terminal emulation
software).
3. Open a VT100 terminal session to the ProCurve Secure Router 7102dl using the
following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to
activate the HP Command Line Interface.
4. Enter enable at the > prompt.
5. Enter the password when prompted or press <Enter> if you have not yet set a password.
www.procurve.com
5991-2112
P C S R
RO URVE ECURE OUTER
Copyright 2005 Hewlett-Packard Development Company, LP
7102dl C
ONSOLE