Technical Data - Genie 480 X Instruction Manual

Under the above-mentioned conditions, the automatic overload guard of the motor is
triggered, whereupon the current feed to the device is interrupted.
In such a case, please take the following steps:
1. Switch the main switch to OFF. Disconnect the main plug from the AC
socket in order to avoid the risk of serious injuries and wait at least 60
minutes until the overload guard has reset. Now tear off excess paper from the
top of the shredder or remove it.
2. Reconnect the main plug to the AC socket and switch to REV. Pull the remaining
paper away from the shredding blades. If necessary, repeat this step.

Technical data:

Shredding type:
Size of cut:
Shredding capacity:
Feed width:
Basket volume:
Input voltage:
Dimensions:
We declare that this device, with regard to its task of the destruction of documents,
fulfils the conditions defined for Security Level P-4 in accordance with DIN 66399.
P-4: Recommended for data media containing particularly sensitive and confidential
data. Material particle area ≤ 160 mm² and for consistent particles: strip width ≤ 6 mm
(e.g. particles 4 x 40 mm).
Cleaning:
Warning! The blades of the device are very sharp! Danger of injury!
1. Switch off the unit.
2. Disconnect the power plug from the power socket.
3. Empty the drip trays regularly.
4. Clean the surface of the housing with a soft, dry, lint-free cloth. Do not use any
solvents or cleaning agents.
5. Remove any residue in the cutting holes with a suitable object.
particle cut
4 x 35 mm (paper)
8 pages DIN A4 (80 g)
approx. 220 mm
12 l
220-240 VAC, 50 Hz, 1.5 A
approx. 322 x 170 x 325 mm
- 11 -