1
Figure 27
1. Flange locknuts (5/16
inch)
2. Flange bolts (5/16 x 1
inch)
6
Installing the Rinse-Pump
Switch, Pump Connectors,
and Fuse
Parts needed for this procedure:
1
Fuse, 40-amp
1
Dash switch
Installing the Rinse-Pump Switch
1. Tilt the operator's seat forward and secure it with the
prop rod
(Figure
28).
3
g024700
3. Faceplate bracket
2
1. Prop rod (operator's seat)
2. Flanged locknut
3. Positive battery terminal
2. Remove the flanged locknut, carriage bolt, and positive
battery cable from the battery
3. Locate the plug where you will install the rinse-tank
switch at the left side of the console
Note: It is the first plug to the right of the lockout key.
1. Hole in dash
4. Remove the plug from the side of the console
29).
5. From below the console, locate the 8-socket electrical
connector labeled "Rinse Tank" in the main harness.
15
Figure 28
4. Carriage bolt
5. Positive battery cable
(Figure
28).
(Figure
1
2
Figure 29
2. 3-position rocker switch
(8-pin )
29).
G022218
(Figure