1-6
Back Panel Connectors
j
USB 2.0/1.1 Port
The USB port supports the USB 2.0/1.1 specication. Use this port or USB devices.
SMA Antenna Connectors (1T1R)j
Use this connector to connect an antenna.
Tighten the antenna cables to the antenna connectors and then move the antenna to a place
where the signal is good.
HDMI Port
(Note 1)
The HDMI port is HDCP 2.2 compliant and supports Dolby TrueHD and DTS
HD Master Audio ormats. It also supports up to 192KHz/24bit 8-channel LPCM
audio output. You can use this port to connect your HDMI-supported monitor. The maximum supported
resolution is 4096x2160@60 Hz, but the actual resolutions supported are dependent on the monitor
being used.
Ater installing the HDMI device, make sure to set the deault sound playback device to HDMI. (The
item name may differ depending on your operating system.)
USB 3.2 Gen 1 Port
The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specication and is compatible to the USB 2.0
specication. Use this port or USB devices.
USB 3.2 Gen 1 Port (White)
The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specication and is compatible to the USB 2.0
specication. Use this port or USB devices. Beore using Q-Flash Plus
fash drive into this port rst.
RJ-45 LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states o the LAN port LEDs.
Connection/
Speed LED
Activity LED
LAN Port
Only for the X570 AORUS ELITE WIFI.
j
(Note 1) For 2nd Generation AMD Ryzen
Vega Graphics processors only.
(Note 2) To enable the Q-Flash Plus unction please visit the "Unique Features" webpage o GIGABYTE's
website.
Connection/Speed LED:
Activity LED:
State
Description
State
Orange
1 Gbps data rate
Blinking
Green
100 Mbps data rate
On
Off
10 Mbps data rate
™
with Radeon
™
Vega Graphics processors/AMD Ryzen
- 13 -
, make sure to insert the USB
(Note 2)
Description
Data transmission or receiving is occurring
No data transmission or receiving is occurring
™
with Radeon
™