Lenovo ideapad 500S-13ISK Hardware Maintenance Manual page 55

Lenovo ideapad 500S-13ISK
Figure 9. Removal steps of system board (continued)
Remove the RJ-45 door in the direction shown by arrow 8.
Note:
• A new system board FRU is shipped with two absorbers. When you replace
the system board, you need to stick these absorbers on it.
• For the absorbers location, please refer to the following figures:
Bottom side of system board
Top side of system board
Attention: The absorber may degrade the WLAN signal quality.
51