Safety Barrier & Glass Door Installation / Removal - Napoleon Ascent Linear BL56 Installation Manual

finishing
EN
10.5 safety barrier & glass door installation / removal
WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and must be installed.
Before the glass door can be removed, the safety barrier must be removed. Lift the safety barrier off the four
shoulder screws and remove from the appliance.
Leave a hand on the glass door during
entire door removal. The glass door is
secured to the firebox with the eight (8)
spring latches. Pull the handles of the
latches forward, then lift/lower the latches
out from the door frame to release the
door. Next, lift the door up until the
bottom edge clears the bottom shoulder
screws of the appliance. Carefully grip the top and bottom of
the door lifting it off the appliance.
note:
These spring latches make up the spring relief system
for the appliance. Ensure the door opens freely and
closes sealed.
note:
When mounting the door, ensure there is equal space
on both the left and the right side. This allows for easy
installation of the front.
Reverse these steps to re-install the door and safety barrier. Ensure safety barrier is installed correctly.
50
W415-3036 / B / 08.19.22
47.1