Projector Information Display - Info Menu; Event Id Code List - Epson CO-W01 User Manual

Note: When the A/V Mute Timer setting is enabled, the lamp uses less power when A/V Mute is
activated.
Parent topic:

Projector Information Display - Info Menu

You can display information about the projector and input sources by viewing the Info menu. However,
you cannot change any settings in the menu.
Select Projector Info to display the settings described below. Select Version to display the projector's
firmware version.
Information item
Lamp Hours
Source
Input Signal
Resolution
Refresh Rate
Sync Info
Status
Serial Number
Event ID

Event ID Code List

Parent topic:
Event ID Code List
If the Event ID option on the Info menu displays a code number, check this list of Event ID codes for the
solution to the projector problem associated with the code.
Adjusting the Menu Settings
Description
Displays the number of hours the projector has been used in High
and Low (Eco) modes since it was turned on
Displays the name of the port to which the current input source is
connected
Displays the input signal setting of the current input source
Displays the resolution of the current input source
Displays the refresh rate of the current input source
Displays information that may be needed by a service technician
Displays information about projector problems that may be needed
by a service technician
Displays the projector's serial number
Displays the Event ID number corresponding to a network problem;
see the list of Event ID codes.
Adjusting the Menu Settings
100