Table of Contents
Advertisement
Setup
Mounting the Attachment
1.
Park the machine on a level surface.
2.
Pull the coupler pins outward and rotate 90° to
lock in the disengaged position.
3.
Make sure that the hydraulic hoses do not block
the attachment point.
4.
Start the machine.
5.
Slowly drive forward until the coupler meets the
attachment hooks. Raise the coupler to hook
it onto the attachment.
6.
Rotate the coupler pin 90° so that it engages
with the attachment assembly.
Figure 3
Figure 4
Note:
Ensure that the coupler pin also inserts
through the hole in the pin channel on the
coupler.
7.
Lower the attachment coupler until the
attachment rests on the ground.
g373475
g383235
5
Figure 5
g373477
Advertisement
Table of Contents
