Troubleshooting - Westinghouse WA43UFA1001 User Manual

TROUBLESHOOTING

If your TV does not operate normally or cannot be turned on, please check the following
troubleshooting questions. Remember also to check any other connected electronic device,
such as DVD or Blu-ray player to pinpoint the problem. If the TV still fails to operate normally,
please contact Westinghouse technical support: westinghouseelectronics.com/support.
The TV does not operate properly
The TV does not respond
when pressing any
buttons
TV cannot be switched on
The remote control does
not work
Power is suddenly
turned off
The video function does not work
No picture & No Sound
Picture appears slowly
after switching on
No or poor color or poor
picture
Horizontal/Vertical bar or
picture shaking
Poor reception on some
channels
• The TV may freeze up during use. Disconnect the power
cord from the power socket for a few minutes. Reconnect the
power cord and try to operate it again as usual.
• Check that the TV is connected to the power supply.
• Make sure all connected AV devices are switched off before
switching on your TV.
• Check to see if there are any objects between the TV and the
remote control causing an obstruction. Ensure that you are
pointing the remote control directly at the TV.
• Install new batteries.
• Remove the batteries from your remote and reinsert to
reinitiate pairing with your TV.
• Hold down the home button on your remote for 10 seconds.
Your remote should be rediscovered within 60 seconds.
• Ensure that the batteries are installed with the correct polarity
(+ to +, - to -).
• Check the power of the TV. The power supply
maybe interrupted.
• Check if the sleep timer is set.
• Check whether the TV is switched on.
• Try another channel. The problem may be caused by
the broadcaster.
• This is normal; the image is muted during the TV startup
process. Please contact your service centre if the picture has
not appeared after five minutes.
• Adjust the settings in the PICTURE menu.
• Try another channel. The problem may be caused
by the broadcaster.
• Check if video cables are connected properly.
• Check for local interference such as an electrical appliance
or power tool.
• The station or cable channel may be experiencing problems;
tune to another station.
• Station signal may be weak, reposition the antenna for
better reception.
• Check for sources of possible interference.
En
17