Table of Contents
Advertisement
ProSense System starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds, the indicator
flashes, the drum rotates shortly.
2. At the end of the load detection, the
indicator
stop flashing. The
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense
System phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense System
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
The ProSense System is not
available with some
programmes, such as Wool,
programmes with short
cycles and without washing
phase.
12.9 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
is
E.g. the rinse phase is running:
12.10 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the button Start/Pause.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pause again.
The washing programme continues.
12.11 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
activate the appliance.
Now, you can set a new washing
programme.
If the ProSense phase is
already carried out and the
water filling is already
started, the new programme
starts without repeating the
ProSense phase. The water
and the detergent are not
drained out in order to avoid
waste. The display shows
the maximum duration of the
programme, updating it
about 20 minutes after the
starting of the new
programme.
ENGLISH
.
25
.
Advertisement
Table of Contents
