First Time Setup - Panasonic TC-P42G10 Operating Instructions Manual

First Time Setup

"First time setup" is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 36-37) is set to "No".
Turn the TV On with the POWER button
or
(TV)
* This setting will be skipped next time if you select "Home Use".
Select your language
Language
English
Be sure to select "Home Use"
Please select your viewing environment
Home Use
Select "Home Use" when using this TV in your home.
Please confirm your selection (Home Use) before pressing OK button.
■
If you select "Store Demonstration" by mistake in ,
confirmation screen will be displayed.
You are selecting the mode for store demonstration
Yes
If you select "Yes", the picture mode will regularly reset
to "Vivid" and a Picture Refresh message will be
displayed on the screen.
Select "No" and return to previous screen
If you select "Yes", Screen enters store demonstration mode.
To display the "Please select your viewing environment" screen again as
shown above and select "Home Use", do one of the following:
• Press and hold down the front POWER button.
• Unplug the TV and plug it again.
Auto channel setup
Select "ANT/Cable setup"
First time setup
Language
ANT/Cable setup
Network setting
VIERA CAST setting
■
Press to exit from
Clock
a menu screen
Input labels
Select "ANT in"
■
ANT/Cable setup
Press to return
ANT in
to the previous
Auto program
screen
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
Typical when Cable/Satellite box is connected to a TV input.
Prevents accidental tuning to an unavailable signal.
16
or
(Remote)
Español Français
select
ok
select
Store Demonstration
ok
select
No
ok
.
next
select
ANT in
set
Cable: Cable TV
Cable
Antenna: Antenna
Not used: Skip TV tuning
select
■
Press to exit from
a menu screen
Note
To change setting
(Language/
ANT/Cable setup/
Network setting/
VIERA CAST setting/
Clock/Input labels)
later, go to Menu
screen
(p. 36)
go to
Select "Auto program"
ANT/Cable setup
next
ANT in Cable
Auto program
select
Select scanning mode
(ALL channels/Analog only/Digital only)
Auto program
ok
All channels
Analog only
select
Digital only
S l OK
Start scanning the channels
Auto program
Available channels (analog/digital) are automatically set.
Progress 8%
Number of analog channels
10
All channels: Scans digital and analog channels
Number of digital channels 0
Press RETURN to quit.
Analog only: Scans Analog channels only
Digital only: Scans Digital channels only
RETURN
Confirm registered channels
select "Apply"
program
Apply Cancel
l Caption Favorite Add
...
... Yes
ok
...
... Yes
... ... Yes
If OK is not pressed after selecting "Apply", the channels will not be saved.
The channel will be saved when no operation is performed for 60 seconds and
the "Manual program" menu will also exit automatically.
If you perform scanning more than twice, previously saved channels are erased.
Network setting
select
First time setup
Language
ANT/Cable setup
ok
Network setting
VIERA CAST setting
Network setting (p. 44-45)
Clock
Input labels
VIERA CAST setting
select
First time setup
Language
ANT/Cable setup
ok
Network setting
VIERA CAST setting
Clock
Input labels VIERA CAST setting (p. 46-47)
17